It looks like this message did not go out so posting again ...

I posted a week ago that my stalling issue was solved.  Well, I spoke too soon.  When I tested further the problem was still there (i.e. idles fine at start, accelerates smoothly, but stumbles and stalls coming to a stop after driving for a few minutes).

This is a GW 2.3 with 1.9 systems, so it is a digijet.

Following up on previous ideas, I did the following:

  *   cleaned the auxiliary air reg with contact cleaner and blew it out with compressed air.
  *   Checked timing (put a mark 2" CW of TDC, revved to 3500, timing mark under timing light slightly left of reference, which seems to be fine).  The timing does advance when watched with a timing light, so the vacuum on the distributor is working.
  *   searching for air leak, replaced old hose on vacuum advance.
  *   I also noticed I have no hose on the vacuum retard, but looking that up many posts say that does not matter.
  *   checked and cleaned connections and grounds

No change with all that.

More importantly, I previously said the van would not idle when I connected the cables of the idle stabilizer.  I did that test again and disconnecting the stabilizer causes the same stalling pattern as the main symptom I am trying to fix, i.e. it stumbles and stalls unless I feather the gas.  With the stabilizer connected it idles fine until I go and drive it and come to a stop.  So, seems to be a connection, but not sure what it is.

Any ideas or suggestions are appreciated.  Thanks in advance.

Dave B
Boise